MidNite Solar E-Panel, OutBack Version, White Aluminum with 250amp 125VDC, Left Hinge

To use the OutBack Surge Protector FW-SP-ACA on an E-Panel you must purchase a stretched case E-Panel. To obtain surge protection in a smaller case use Delta Lightning Arrestors.

OutBack Plus white aluminum shown with an MX60 and FX inverter mounted

The MidNite Solar E-Panel comes standard with the basic over-current protection and disconnects required to install your renewable energy system. It can also expand to grow as your needs arise.

Inverter installation has just gone from hours to minutes with MidNite Solar's E-Panel. These disconnect boxes can easily be stacked horizontally or vertically to save space.

Breaker: 250 Amp 125 VDC
Material: White Aluminum
Light Side Hinge: hinge on left, circuit breakers on the left and charge control bracket on the right.
Dimensions: 14" X 12" X 28”
Weight: 20 Lbs

Features

• Small size compared to existing disconnect and over current solution
• Pre-wired to save time, money and complexity. All field wiring connections clearly labeled
• White powder coated aluminum or standard gray powder coated steel
• Easily expands to accoummodate additional inverters
• Six slots for din rail breakers, PV, Wind, Hydro, AC distribution
• Pre-wired 50 amp 240VAC rated Inverter AC bypass switch
• Pre-wired 50 amp 240VAC rated AC Input disconnect
• Bus bars for Battery Plus, Battery Minus and ground
• Mounting hardware for Inverter and charge controller
• Mounting brackets for hanging E-Panel on wall
• Heavy duty 175 amp AC distribution block
• ETL listed to UL and Canadian standards
• Standard Right hand hinged door to mount inverter
• Knockouts for AC and DC conduits
• Charge control bracket (CCB)
• Cut outs for two GFCI outlets
• DC Inverter battery breaker
• Internal inverter cables